threshold-client

Configures the client threshold limit. This is the threshold limit per client that, when exceeded, signals the event.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

threshold-client <1-65535>

Parameters

threshold-client <1-65535>


threshold-client <1-65535>	Configures the client threshold limit <1-65535> – Set the threshold limit for a 60 second window from 1 - 65535.

Examples

nx9500-6C8809(config-test-signature-test)#threshold-client 88

nx9500-6C8809(config-test-signature-test)#show context
 signature test
  bssid 11-22-33-44-55-66
  src-mac 00-1E-E5-EA-1D-60
  dst-mac 55-66-77-88-99-00
  frame-type beacon
  ssid-match ssid PrinterLan
  filter-ageout 8
  threshold-client 88
  payload 1 pattern test offset 1
nx9500-6C8809(config-test-signature-test)#

Related Commands


no (wips-signature-config-mode-command)	Removes the client threshold limit configured with a WIPS policy signature